Maintenance Knowledge of Gantry Crane

1. Lubrication

The working performance and service life of crane mechanisms depend on lubrication to a great extent.

When lubricating, please refer to the manual for the maintenance and lubrication of mechanical and electrical products. Grease should be injected once a week for traveling crane and crane trolley. When the winch is filled with industrial gear oil (sy1172-80) 200, the oil level should be checked frequently and replenished in time.

2. Wire rope

Pay attention to the broken wire condition of the wire rope. If there is broken wire, broken strand or abrasion reaches the scrapping standard, the new rope should be replaced in time. The steel wire rope that can be selected includes phosphating coating steel wire rope, galvanized steel wire rope and smooth surface steel wire rope.

single girder gantry crane of Aicrane for sale
Get a Free Quote

3. Spreader

The spreader must be checked regularly.

4. Pulley block

Mainly check the wear of rope groove, whether the flange is cracked and whether the pulley is stuck on the shaft.

5. Wheel

Check the flange and tread regularly, and replace the new wheel when the wear or crack of the flange reaches 10% thickness.

When the diameter difference between the two driving wheels on the tread exceeds D / 600, or there are serious scars on the tread, the wheel shall be polished again.

6. Brake

Check once per shift.

The brake shall act accurately and the pin shaft shall not be stuck. The brake shoe should fit the brake wheel correctly, and the brake shoe clearance should be equal when the brake is released.

Aicrane double girder crane for sale
Get a Free Quote

7. Causes and preventive measures of oil leakage of reducer

There are three common reasons for oil leakage of reducer

  • Due to the unreasonable design of the manufacturer: in the design process, there is no special vent or the vent is too small and other design defects will cause the internal and external pressure of the reducer to be unbalanced, resulting in leakage fault, and eventually lead to the leakage fault of the reducer lubricating oil. It is also possible that in the process of long-term use, the joint surface of the reducer is not tightly sealed, resulting in leakage.
  • Due to the limited level of processing technology, the precision of the contact surface of the box is not enough, resulting in poor sealing performance and oil leakage.
  • Due to the improper maintenance of operators or maintenance personnel in the daily use process, the internal pressure is higher than the external pressure due to the improper maintenance of the operators or maintenance personnel. At the same time, too much oil and no tightening of fasteners will cause the joint surface between the two boxes not tight, resulting in oil leakage.

In order to effectively prevent the reducer from oil leakage, the manufacturer should improve the process level and optimize the design scheme: a ventilation device can be added on the filler hole cover to ensure the internal and external pressure is balanced and unobstructed. At the same time, the process precision between the joint surface of the two boxes should be improved in the design process, so as to prevent the oil leakage fault caused by the loose contact surface. At the same time, it is also necessary to do a good job of maintenance in the process of daily use, and regularly check whether the air vent, oil volume, box body and fasteners are in the normal state.

best talbe lamps best rated diaper bags